SD Card Driver ConfigurationRETAIN/CHANGERemark
Use SD Card Driver CHANGEAs you are using the SD Card to store the images, you require to use the SD Card Driver. Unchecked by default. Select this option.
 Driver ImplementationRETAINSelected as Dynamic by default. you cannot change this option. Retain this.
 Number of SD Card Driver ClientsCHANGESD Card is used by the Graphical Display as well as the TCP/IP stack, to read the images. Default is 1. Change this to 2.
 SD Card Driver IndexRETAINDefault is DRV_SDCARD_INDEX_0. Retain this.
 Maximum Driver IndecesRETAINMaximum Driver Index. Retain the default selection.
 SD Card Data Queue SizeRETAINDefault value is 10. Retain this.
 Clock To UseCHANGEDefault is CLK_BUS_PERIPHERAL_1. Change it to CLK_BUS_PERIPHERAL_2, because CLK_BUS_PERIPHERAL_2 is a clock source for the SPI module. The SPI module is used by the SD Card driver as the communication interface module.
 SD Card Speed(Hz)RETAINDefault is 20000000. Retain this.
 Enable Write Protect Check?CHANGEDefault write protect check is enabled. Micro SD Card do not have write protection line. Disable this option.
 Chip Select PortCHANGEDefault is PORT_CHANNEL_A. Change this to PORT_CHANNEL_B. For SD Card operating in SPI mode, the DATA3/CD line of SD Card is used as chip select line and the same is connected to port pin RB14
 Chip Select Port BitCHANGEDefault is PORTS_BIT_POS_1. Change this to PORTS_BIT_POS_14. For SD Card operating in SPI mode, the DATA3/CD line of SD Card is used as chip select line and the same is connected to port pin RB14
 SPI Driver Instance to use for SD Card DriverRETAINDefault is 0. Retain this.
 Register With FilesystemRETAINAs you access the contents of the SD Card as files, you require the SD Card to be registered with the FileSystem. Default is checked. Retain this.